Committee of Adjustment

Application for B7/2020P is made for consent to convey and partial discharge of mortgage of 533.81 square metres of land for a single detached dwelling. 4,067 square metres of land; is hereby GRANTED The above decision is subject to the following conditions: To the Satisfaction of the Director of Public Works 1. Ensure all lots are serviced with, at a minimum, an individual 20 mm Ø water service and 125 mm Ø sanitary sewer lateral in accordance with Town standards. Installation of any service will require a Temporary Works Permit(s) to be obtained and approved by the Public Works Department. If existing services are proposed for reconnection, such services shall be inspected by the Public Works Department to determine their condition is satisfactory prior to connection. The applicant shall bear all costs associated with these works. 2. Submit a drawing indicating the location of the individual water services and sanitary laterals for all lots confirming no existing or proposed service branches from, or through any proposed lot lines to other lands, and from or through the remnant parcel to other lands. Locate cards are required after the installation of new services. 3. Obtain approval for a Driveway Entrance & Culvert Permit, as applicable, issued through the Public Works department, to Town standards. The driveway entrance shall be located on the north side of the proposed lot. The applicant shall bear all costs associated with these works. 4. Submit a comprehensive Lot Gra

Application for B8/2020P is made for consent to convey and partial discharge of mortgage of 533.81 square metres of land for a single detached dwelling; is hereby GRANTED The above decision is subject to the following conditions: To the Satisfaction of the Director of Public Works 1. Ensure all lots are serviced with, at a minimum, an individual 20 mm Ø water service and 125 mm Ø sanitary sewer lateral in accordance with Town standards. Installation of any service will require a Temporary Works Permit(s) to be obtained and approved by the Public Works Department. If existing services are proposed for reconnection, such services shall be inspected by the Public Works Department to determine their condition is satisfactory prior to connection. The applicant shall bear all costs associated with these works. 2. Submit a drawing indicating the location of the individual water services and sanitary laterals for all lots confirming no existing or proposed service branches from, or through any proposed lot lines to other lands, and from or through the remnant parcel to other lands. Locate cards are required after the installation of new services. 3. Obtain approval for a Driveway Entrance & Culvert Permit, as applicable, issued through the Public Works department, to Town standards. The driveway entrance shall be located on the north side of the proposed lot. The applicant shall bear all costs associated with these works. 4. Submit a comprehensive Lot Grading & Drainage Plan for all

Application A25/2020P for relief of Section 13.2 (a) “Minimum Lot Area” – to permit a minimum lot area of 533 square meters whereas the by-law requires 700 square meters, Section 13.2 (b) “Minimum Lot Frontage” – to permit a minimum lot frontage of 15.2 meters whereas the by-law requires 19 meters, Section 13.2 (c) “Maximum Lot Coverage” – to permit a maximum lot coverage of 50% whereas the by-law allows 30%, Section 13.2 (d) “Minimum Front Yard” – to permit a minimum front yard of 6 meters whereas the by-law requires 7.7 meters and Section 13.2 (e) “Minimum Interior Side Yard” – to permit a minimum interior side yard of 1.5 meters whereas the by-law requires 1.8 meters, is hereby: GRANTED The above decision is based on the following reasons: 1. The variance is minor in nature given the surrounding area and the reduced lot area can still comfortably accommodate the proposed dwelling, landscaped amenity area, parking and drainage, smaller lot sizes are increasingly becoming common, given modern civil design and infrastructure standards, as it will provide an opportunity to enhance the public realm and streetscape and the reduced parcel size can still comfortably accommodate a new dwelling. 2. The general purpose and intent of the Zoning By-Law is maintained. 1. The intent of the Official Plan is maintained. 4. The proposal is desirable for the appropriate development and/or use of the land because it will allow for the creation of an additional residential building lot on a la

Application for relief of Section 13.2 (a) “Minimum Lot Area” – to permit a minimum lot area of 533 square meters whereas the by-law requires 700 square meters, Section 13.2 (b) “Minimum Lot Frontage” – to permit a minimum lot frontage of 15.2 meters whereas the by-law requires 19 meters, relief of Section 13.2 (c) “Maximum Lot Coverage” – to permit a maximum lot coverage of 50% whereas the by-law allows 30%, Section 13.2 (d) “Minimum Front Yard” – to permit a minimum front yard of 6 meters whereas the by-law requires 7.7 meters and Section 13.2 (e) “Minimum Interior Side Yard” – to permit a minimum interior side yard of 1.5 meters whereas the by-law requires 1.8 meters, is hereby: GRANTED The above decision is based on the following reasons: 1. The variance is minor in nature given the surrounding area and the reduced lot area can still comfortably accommodate the proposed dwelling, landscaped amenity area, parking and drainage, smaller lot sizes are increasingly becoming common, given modern civil design and infrastructure standards, as it will provide an opportunity to enhance the public realm and streetscape and the reduced parcel size can still comfortably accommodate a new dwelling. 2. The general purpose and intent of the Zoning By-Law is maintained. 1. The intent of the Official Plan is maintained. 4. The proposal is desirable for the appropriate development and/or use of the land because it will allow for the creation of an additional residential building lot on a la

BE IT RESOLVED THAT this Meeting of the Committee of Adjustment Hearing be adjourned until the next regular meeting.